Cisco 300-101 Dumps

Exam: CCNP Implementing Cisco IP Routing (ROUTE v2.0)

300-101 Premium VCE File
300-101.vce - Exam-Labs Verified - Instant Download
Get Latest & Verified 300-101 Exam Questions with 30-Days Free Updates
722 Questions & Answers
 $39.99

Free 300-101 Exam Questions in VCE Format
File Votes Size Last comment
2 13.94 MB  
5 4.91 MB Oct 11, 2018
Play Cisco 300-101 VCE files with Avanset VCE Simulator
 

Cisco 300-101 Exam Tutorial

Showing 1-20 of 420 Questions   (Page 1 out of 21)


Question No : 1 - Topic 1

Which statement about the use of tunneling to migrate to IPv6 is true?

A. Tunneling is less secure than dual stack or translation.
B. Tunneling is more difficult to configure than dual stack or translation.
C. Tunneling does not enable users of the new protocol to communicate with users of the old protocol without dual-stack hosts.
D. Tunneling destinations are manually determined by the IPv4 address in the low-order 32 bits of IPv4-compatible IPv6 addresses.


Question No : 2 - Topic 1

Under which condition does UDP dominance occur?

A. when TCP traffic is in the same class as UDP
B. when UDP flows are assigned a lower priority queue
C. when WRED is enabled
D. when ACLs are in place to block TCP traffic


Question No : 3 - Topic 1

Refer to the exhibit.
Cisco 300-101 question 3
Based on this FIB table, which statement is correct?

A. There is no default gateway.
B. The IP address of the router on FastEthernet is 209.168.201.1.
C. The gateway of last resort is 192.168.201.1.
D. The router will listen for all multicast traffic.


Question No : 4 - Topic 1

Which three problems result from application mixing of UDP and TCP streams within a
network with no QoS? (Choose three.)

A. starvation
B. jitter
C. latency
D. windowing
E. lower throughput


Question No : 5 - Topic 1

Which two actions must you perform to enable and use window scaling on a router?
(Choose two.)

A. Execute the command ip tcp window-size 65536.
B. Set window scaling to be used on the remote host.
C. Execute the command ip tcp queuemax.
D. Set TCP options to "enabled" on the remote host.
E. Execute the command ip tcp adjust-mss.


Question No : 6 - Topic 1

A network engineer notices that transmission rates of senders of TCP traffic sharply
increase and decrease simultaneously during periods of congestion. Which condition
causes this?

A. global synchronization
B. tail drop
C. random early detection
D. queue management algorithm


Question No : 7 - Topic 1

Which switching method is used when entries are present in the output of the command
show ip cache?

A. fast switching
B. process switching
C. Cisco Express Forwarding switching
D. cut-through packet switching


Question No : 8 - Topic 1

Refer to the exhibit.
Cisco 300-101 question 8
A network administrator checks this adjacency table on a router. What is a possible cause
for the incomplete marking?

A. incomplete ARP information
B. incorrect ACL
C. dynamic routing protocol failure
D. serial link congestion


Question No : 9 - Topic 1

A network administrator executes the command clear ip route. Which two tables does this
command clear and rebuild? (Choose two.)

A. IP routing
B. FIB
C. ARP cache
D. MAC address table
E. Cisco Express Forwarding table
F. topology table


Question No : 10 - Topic 1

Which three TCP enhancements can be used with TCP selective acknowledgments?
(Choose three.)

A. header compression
B. explicit congestion notification
C. keepalive
D. time stamps
E. TCP path discovery
F. MTU window


Question No : 11 - Topic 1

A network administrator uses IP SLA to measure UDP performance and notices that
packets on one router have a higher one-way delay compared to the opposite direction.
Which UDP characteristic does this scenario describe?

A. latency
B. starvation
C. connectionless communication
D. nonsequencing unordered packets
E. jitter


Question No : 12 - Topic 1

Which method allows IPv4 and IPv6 to work together without requiring both to be used for
a single connection during the migration process?
A. dual-stack method
B. 6to4 tunneling
C. GRE tunneling
D. NAT-PT


Question No : 13 - Topic 2

PPPoE is composed of which two phases?

A. Active Authentication Phase and PPP Session Phase
B. Passive Discovery Phase and PPP Session Phase
C. Active Authorization Phase and PPP Session Phase
D. Active Discovery Phase and PPP Session Phase


Question No : 14 - Topic 2

Prior to enabling PPPoE in a virtual private dialup network group, which task must be
completed?

A. Disable CDP on the interface.
B. Execute the vpdn enable command.
C. Execute the no switchport command.
D. Enable QoS FIFO for PPPoE support.


Question No : 15 - Topic 2

A network engineer has been asked to ensure that the PPPoE connection is established
and authenticated using an encrypted password. Which technology, in combination with
PPPoE, can be used for authentication in this manner?

A. PAP
B. dot1x
C. IPsec
D. CHAP
E. ESP


Question No : 16 - Topic 2

Which protocol uses dynamic address mapping to request the next-hop protocol address
for a specific connection?

A. Frame Relay inverse ARP
B. static DLCI mapping
C. Frame Relay broadcast queue
D. dynamic DLCI mapping


Question No : 17 - Topic 2

A corporate policy requires PPPoE to be enabled and to maintain a connection with the
ISP, even if no interesting traffic exists. Which feature can be used to accomplish this task?

A. TCP Adjust
B. Dialer Persistent
C. PPPoE Groups
D. half-bridging
E. Peer Neighbor Route


Question No : 18 - Topic 2

Which PPP authentication method sends authentication information in clear text?

A. MS CHAP
B. CDPCP
C. CHAP
D. PAP


Question No : 19 - Topic 2

Which statement is true about the PPP Session Phase of PPPoE?
A. PPP options are negotiated and authentication is not performed. Once the link setup is
completed, PPPoE functions as a Layer 3 encapsulation method that allows data to be
transferred over the PPP link within PPPoE headers.
B. PPP options are not negotiated and authentication is performed. Once the link setup is
completed, PPPoE functions as a Layer 4 encapsulation method that allows data to be
transferred over the PPP link within PPPoE headers.
C. PPP options are automatically enabled and authorization is performed. Once the link
setup is completed, PPPoE functions as a Layer 2 encapsulation method that allows data
to be encrypted over the PPP link within PPPoE headers.
D. PPP options are negotiated and authentication is performed. Once the link setup is
completed, PPPoE functions as a Layer 2 encapsulation method that allows data to be
transferred over the PPP link within PPPoE headers.


Question No : 20 - Topic 3

You are a network engineer with ROUTE.com, a small IT company. They have recently
merged two organizations and now need to merge their networks as shown in the topology
exhibit. One network is using OSPF as its IGP and the other is using EIGRP as its IGP. R4
has been added to the existing OSPF network to provide the interconnect between the
OSPF and EIGRP networks. Two links have been added that will provide redundancy.
The network requirements state that you must be able to ping and telnet from loopback 101
on R1 to the OPSF domain test address of 172.16.1.100. All traffic must use the shortest
path that provides the greatest bandwidth. The redundant paths from the OSPF network to
the EIGRP network must be available in case of a link failure. No static or default routing is
allowed in either network.
A previous network engineer has started the merger implementation and has successfully
assigned and verified all IP addressing and basic IGP routing. You have been tasked with
completing the implementation and ensuring that the network requirements are met. You
may not remove or change any of the configuration commands currently on any of the
routers. You may add new commands or change default values.
Cisco 300-101 question 20


Showing 1-20 of 420 Questions   (Page 1 out of 21)

300-101 Training Products

300-101 Premium File

  • 722 Questions & Answers
  • Instant Download
  • $39.99

300-101 Training Course

  • 91 Video Lectures
  • Watch Online
  • $24.99

300-101 Study Guide

  • 534 PDF pages
  • Instant Download
  • $24.99

  • Instant Download
  • $0.00

Site Search:

Close

Close
NOVEMBER DISCOUNT: 20%

Exam-Labs PREMIUM Files

Get 20% Discount on all Exam-Labs.com PREMIUM files!



Enter Your Email Address to Receive Your 20% Discount Code

A Confirmation Link will be sent to this email address to verify your login

We value your privacy.
We will not rent or sell your email address

Close
Download Free Demo of VCE
Exam Simulator

Experience Avanset VCE Exam Simulator for yourself.


Simply submit your e-mail address below to get started with our interactive software demo of your free trial.


Enter Your Email Address

Free Demo Limits: In the demo version you will be able to access only first 5 questions from exam.